3DLadnik

It Works!

My new printer finally made it right! Now it can do almost anything. I call it "Lad-1.0".

I was able to eliminate the first layer and plastic’s lamination problems, issues with the filling thread stop motion, shift the printed layers and skip the steps of the stepper motor. Now this printer is able to combine two materials in one printing process! Steady, precise and quickly works with nozzles from 0.2 mm to 1.0 mm and with the layer height of 20 μm to 300 μm.

What you will need just a few purchased parts, a little bit of knowledge, following exact directions and a some handwork, and your creative thoughts have a chance to materialize and became reality. It's almost a magic.

Now I can carry my own and other ideas into the material world.

This is amazing!